Car Sort: Color Puzzle Level 340 Solution Walkthrough

Read the garage above the ice

The opening upper area exposes red on the left, yellow around the round garage, and green on the right. Clear red first, then yellow. Green follows once the top-right bend is free. These batches lower the large center counter without filling the road beside the frozen row.

Use this route reference:

red upper stack → yellow center garage → green right stack → purple/pink side release → frozen pale-cyan row → lower green/purple/orange columns → top orange/lavender/green/blue towers → returning pink/red cleanup

The counter 5 is a phase marker, not an instruction to tap five different colors. Keep feeding it complete matching groups and allow every number change to settle.

Clear the small upper stacks

After the first red, yellow, and green groups, purple and pink become visible beside the center garage. Move purple through the left side, then pink through the open right. Do not begin the frozen cyan row while a purple or pink marker remains above it.

The correct checkpoint shows the round garage with a reduced number, both neighboring stacks mostly empty, and an unobstructed horizontal road directly above the ice. If one upper stack remains colored, complete it before attempting to release the divider.

Remove the frozen cyan divider

Pale cyan spans almost the entire board. Clear it as one long batch. This row occupies too much space to mix with another color, and its cars need both outside corners to reach the matching garage.

When cyan disappears, it leaves a wide dark strip connecting the upper and lower halves. Preserve that strip as a buffer. Let the final cyan marker vanish before tapping the newly uncovered lower silos.

Open the three lower silos

The lower row exposes green on the left, purple in the middle, and orange or yellow on the right. Green should move first through the left entrance. Purple follows into the space green creates. Orange is safest last because it approaches the same right bend later used by the upper tower wave.

If a silo shows a deeper face after its first color, wait for the active counter. Do not alternate between all three silos. Each complete column should leave one empty vertical route beneath the former cyan strip.

At the lower reset, no marker should remain below the ice line and the center buffer should be completely dark. That is the signal to reverse direction and drain the tall towers.

Use the former ice row as a traffic gauge

The long dark strip is wide enough to reveal routing mistakes immediately. During a correct lower batch, it shows one color moving from a silo toward the outside road. During the tower phase, it should stay empty. If a lower marker remains there when a tower opens, finish that lower color before letting the tower descend.

Do not park a single car in the strip as a spacer. Its purpose is to separate upper and lower phases, and preserving it gives the next tall column a clean vertical connection.

Work across the upper tower row

The four towers reveal orange, lavender, green, and blue, with smaller dark or cyan faces between layers. Start with the complete tower nearest the open left entrance. Lavender needs the center route, green follows after it, and blue should wait until the right edge is clear.

Orange can appear both before and after the tower transition. Finish the orange group already on the road before exposing a deeper tower face. Same-colored layers are safe to combine only when they share the same open entrance and no other color is moving.

Pink and red return around the round garage during cleanup. Clear the nearer center face before the remaining tower color because the center stack controls the shared top road.

Recovery by divider state

If the cyan row is still present, every problem belongs to the upper phase. Finish red, yellow, green, purple, or pink around the round garage. Do not touch a lower silo. If the cyan row is gone but the top towers remain locked, complete the active green, purple, or orange lower column.

A blockage on the upper-right bend after the tower release usually means orange and blue were mixed. Finish whichever color is closer to its garage. A car stalled on the former cyan strip points to an incomplete lower silo or center cleanup group.

Restart only if different partial colors occupy both ends of the dark center strip with no exposed matching source. Most errors can be fixed because the cleared divider provides several buffer spaces once one complete batch is removed.

The Level 340 solution treats the board as two rooms joined by a removable wall. The small upper stacks reduce the central garage, cyan removes the wall, the lower silos create vertical space, and the tall upper towers then drain through a board that no longer has competing traffic below.

Before the last pink or red cleanup, verify that the round garage has reached its final count, the former ice row contains no moving marker, and all three lower silo entrances are empty. If a tower still displays a colored front, complete that face first. These checks ensure the final center batch travels directly instead of meeting a late reserve car.

Wait for every counter animation to finish before making the final selection; the visible face can change during that brief transition.